by Rob Heavey
THIS FLOW IS OUTDATED. PLEASE USE AS A TEMPLATE TO MAKE YOUR OWN.
This Flow automatically renames Pokemon with the help of Calcy IV. It waits until you switch back to Pokemon Go, then gives you instructions. After it is started, it asks how many Pokemon you would like to rename. It then scrolls through that many Pokemon and automatically renames them all using screen touch commands. There is an option to restart at the end.
Created using a Samsung Note5, screen resolution =1440x2560. All screen touches are commanded as a percentage of the total screen size. Your device layout may be slightly different for these two apps, some tweaking may be necessary.
WARNING: Does not work on very large Pokemon or others that obstruct the view of the CP meter. This is a limitation of Calcy IV. Additionally, do not use on your entire inventory. This could take around 2.5 hours if you have 800 Pokemon!!!
* Paid Version (over 30 blocks)
* Calcy IV app (free!)
* Calcy IV button must be located near (x,y)=(1328px,454px)≈(92%,18%) [(100%,100%) is bottom right]
*Once you get the Calcy IV button in the right place, use settings to lock it in place (it's easy to move accidentally!).
*Test the app out a few times on a small number of Pokemon to make sure it is working correctly.
*Verifies that Pokémon Go is installed.
*Verifies that Calcy IV is installed.
*Automatically opens Calcy IV.
*Automatically opens Pokémon Go.
*Increased delay from 0.6s to 0.7s between appraisal clicks.
*Occasionally misses a swipe or two. Just renames the same Pokémon twice. I'll look into this later.
Rate and review within the app in the Community section.