Ringer to vibration automatic

1. Automate Community
2. Personalization

Automaticly sets ringer mode to vibration when at specified region (cell towers) and back to normal when leaving that area.
Additionally it sets to vibration on calendar event (busy) and back to normal when event ends.

Onetime setup:
- Turn off logging, as it will log several lines every 5 minutes.
- Top left "await event" block: click on "calendar uri" and choose the calendar you use for your appointments
- Top right under area labels "when near cell" blocks: when you are at the place you want your phone set to vibration, e.g. workplace, school, hospital (one cell block for each area), click on "cell towers" and select all. Repeat that step from time to time to add new towers to the list (tick the unmarked towers).
I suggest to rename label to specific area name to find correct near cell blocks easier later.
- If more areas are needed, just mark the most right label and near cell block, copy it and past it to the right. Then connect the former last red near cell no to the in of new copied near cell, its red no with goto normal (33) and the green yes with goto vibration (31). You see how it should look like between area 1 and 2 :)

Note: The pre added cell tower is just a place holder and can be removed on first setup. It's set to prevent flow setting phone to vibration on EVERY location you start the flow without adding specific cell towers.
To delete it you can
- Unmark the cell tower when you are at your desired location and click to select towers OR
-click the fx right of it first and delete all the text, then hit save and click on now empty field again to select your cell towers.